Installation: ============= As with any autoconfiguring GNU software, installation is as easy as this: sysprompt> ./configure sysprompt> make sysprompt> make check sysprompt> make install Known to work with: - Linux/x86, EGCS-1.1.2 or GCC 2-95. The "make" step takes about 10 minutes, on a 586 DX / 133 MHz / 64 MB or about 2 minutes on a P-III /550 MHz / 512 MB. More detailed installation instructions can be found in the documentation, in the doc/ directory. Problems with CLN: ================== You should use at least CLN V1.0.2, since all earlier ones are somewhat buggy. Even V1.0.1 has a few problems and GiNaC will not support older versions. Please install it properly on your system before continuing with GiNaC.