4 As with any autoconfiguring GNU software, installation is as easy as this:
9 sysprompt> make install
12 - Linux/x86, EGCS-1.1.2 or GCC 2-95.
14 The "make" step takes about 10 minutes, on a 586 DX / 133 MHz / 64 MB or
15 about 2 minutes on a P-III /550 MHz / 512 MB.
17 More detailed installation instructions can be found in the documentation,
18 in the doc/ directory.
24 You should use at least CLN V1.0.2, since all earlier ones are
25 somewhat buggy. Even V1.0.1 has a few problems and GiNaC will not
26 support older versions. Please install it properly on your system
27 before continuing with GiNaC.